Support logging from Nasal at custom levels.

[flightgear.git] / README.plib

diff --git a/README.plib b/README.plib
index b9116697ae387baf0ae89c62d05d48648e06f49f..6743ce9808b7d2f83ebcc5ddf7d1b11579ecf0f9 100644 (file)
--- a/README.plib
+++ b/README.plib
@@ -1,10 +1,12 @@
-You *must* have the plib version 1.1.x or later installed on your
-system to build the FGFS simulator!"  Special note: Flight Gear is no
-longer compatible with the 1.0.x versions of plib.
+[This file is mirrored in both the FlightGear and SimGear packages.]
+
+You *must* have plib version 1.8.4 or later installed on your system
+to build FlightGear!"  Flight Gear is no longer compatible with the
+earlier versions of the library.
 
 You can get the latest version of plib from:
 
-    http://www.woodsoup.org/projs/plib/
+    http://plib.sourceforge.net
 
 Build notes:
 
@@ -13,3 +15,34 @@ and use all of plib's defaults.  Then run "make" followed by "make
 install".  By default, plib installs itself into /usr so if you don't
 like this, be sure to specify an alternate prefix such as --prefix=/usr/local
 
+As of this writing (2007-11-18), many linux distributions are shipped with a 
+working version of plib, so chances are that this library is already 
+installed. It should be noted, that currently plib version no longer compiles
+using recent versions of gcc (confirmed on version gcc 4.1.2, as shipped with 
+SuSe 10.2). As a workaround, it is possible to either use plib SVN. Run the 
+following commands: 
+
+
+svn co https://plib.svn.sourceforge.net/svnroot/plib/trunk plib
+cd plib
+./autogen.sh
+./configure
+make
+make install
+
+Alternatively, it is relatively straightforward to fix the compilation 
+problems in plib
+
+The two errors reported are the following:
+ssgaSky.h:107: error: extra qualification ‘ssgaCelestialBodyList::’ on member ‘ssgaCelestialBodyList’
+ssgaSky.h:195: error: extra qualification ‘ssgaCloudLayerList::’ on member ‘ssgaCloudLayerList’
+
+To fix, open the file plib-1.8.4/src/ssgAux/ssgaSky.h
+
+and change line 107 to read:
+  ~ssgaCelestialBodyList () { removeAll(); }
+and change line 195 to read:
+  ~ssgaCloudLayerList () { removeAll(); }
+
+In other words, remove the "extra qualification" parts from both lines. 
+After these changes, plib-1.8.4. should build and install correctly.